Author: Günther Simon
Date: 01:44:59 12/03/05
Go up one level in this thread
On December 03, 2005 at 03:10:50, George Speight wrote: >On December 03, 2005 at 02:32:17, Graham Banks wrote: > >>On December 03, 2005 at 01:27:16, George Speight wrote: >> >>> >>>I want to change a particular setting in the parameters for an engine inside >>>chessbase. I load the engine to play, and then open up its parameters. I make >>>the change and then click "ok". The change has taken place. But then i load >>>another engine to play and later go back and load the engine again that i made >>>the setting change in. Now it has gone back to the original setting that was >>>present before i made the change. What is the procedure i use that when i make >>>the setting change it is permanent, and i dont have to worry about making it >>>each time i load the engine. thanks in advance, George >> >>When you load the parameters, click 'save'. >>Then whenever you use the engine again, go into parameters, click load and load >>the saved parameter file. >>I'm not sure that you can get around having to do this each time you load the >>engine. >> >>Graham. >Thanks, Graham, for taking the time to help me. I really appreciate people like >you. Best regards, George If it is an UCI or WB2UCI program you can create as much own changed versions, as you want and give them any name you like, after this you don't have to care anymore, if it really has the settings you made up. Create a new UCI engine with your desired name and change the parameters as desired. Save the parameters with your desired name and from now on this particulary engine is always loaded with _your_ saved changes. This is not possible for the few CB natives. Regards, Guenther
This page took 0 seconds to execute
Last modified: Thu, 15 Apr 21 08:11:13 -0700
Current Computer Chess Club Forums at Talkchess. This site by Sean Mintz.