Author: Graham Banks
Date: 23:32:17 12/02/05
Go up one level in this thread
On December 03, 2005 at 01:27:16, George Speight wrote: > >I want to change a particular setting in the parameters for an engine inside >chessbase. I load the engine to play, and then open up its parameters. I make >the change and then click "ok". The change has taken place. But then i load >another engine to play and later go back and load the engine again that i made >the setting change in. Now it has gone back to the original setting that was >present before i made the change. What is the procedure i use that when i make >the setting change it is permanent, and i dont have to worry about making it >each time i load the engine. thanks in advance, George When you load the parameters, click 'save'. Then whenever you use the engine again, go into parameters, click load and load the saved parameter file. I'm not sure that you can get around having to do this each time you load the engine. Graham.
This page took 0 seconds to execute
Last modified: Thu, 15 Apr 21 08:11:13 -0700
Current Computer Chess Club Forums at Talkchess. This site by Sean Mintz.